![]() ![]() /Verify this switch is not necessary but it is advisable to use it to verify the saved image file.Ĭapturing the Sysprep image will take a long time until it completes, depending on the updates, applications and data stored.Īfter the capture has been completed, the system image will be stored on the external hard drive.Fast is a switch for faster image acquisition./Compress is a switch which is necessary to compress the image file.You can provide your own description to identify it easily. “Windows 7” is a description of the image file.G:\image.wim is the exact path to resulting image file with a name that you can choose yourself.D: is the drive on which Sysprep has been applied.Imagex /capture Source-drive Destination-file “Image Description” /compress fast /verify Imagex /capture d: g:\image.wim “Windows 7” /compress fast /verify (In my example is the drive e:\) To save the Sysprep prepared image, type the following command: Now, access the disk that contains the WinPE disk (and imagex.exe file) by entering the corresponding letter on the command line. G:\ – The external USB drive which will store the image file.D:\ – The hard drive on to which Sysprep has been applied.So, in my example, the disks are as follows: Obviously, you can skip the disk letters that have already been recognized as the WinPE disk and Sysprep.įor your convenience you can note the drive letter assignments so you know them when you need to type subsequent commands to save the image. Then you need to find the external hard drive plugged into the USB port on which we’ll save the image of the operating system. To identify the disk which runs Sysprep (usually c: \ or d:\) navigate to the location D:\Windows\ System32\Sysprep using the command cd (change directory), then run the dir command and make sure that this folder contains the file Sysprep_succeeded.tag. To identify the WinPE disc, look for a file called imagex.exe after you hit the dir command for each disk. For example, type c: and then the dir command to see the list of folders held on the drive. You can start by looking separately at each drive letter’s corresponding files – that will help you identify what’s installed on each drive. The Diskpart tool can help you identify the connected drives of your computer. You’re now ready to proceed to capture the image.Īt this point you need to find out which drive letters Windows has mapped to the WinPE disk, the computer’s internal hard drive and the external drive plugged into the USB port. Immediately after the Windows files have automatically loaded, your computer will open the WinPE command prompt. When you start the computer press a button to start from the CD when you see the corresponding message. Ensure your WinPE CD/DVD or thumb drive is inserted so it runs once you leave the BIOS settings. ![]() Then, boot the computer and enter the BIOS setup to set the first boot device to CD / DVD or USB if you installed your WinPE disk on a thumb drive. Once you have completed the Sysprep process and the source computer is now switched off you can proceed to the next step, which is capturing the Windows 7 image.įirst connect an external hard drive to the USB port of your computer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |